Updated Free Fortinet FCSS_NST_SE-7.4 Test Engine Questions with 42 Q&As
The Best Fortinet Certified Solution Specialist FCSS_NST_SE-7.4 Professional Exam Questions
NEW QUESTION # 11
Refer to the exhibit, which shows the output o! the BGP database.
Which two statements are correct? (Choose two.)
- A. The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.
- B. The first four prefixes are being advertised using a legacy route advertisement.
- C. The output shows all prefixes advertised by all neighbors as well as the local router.
- D. The advertised prefix of 10.20.30.0'24 was configured using the network command.
Answer: C,D
NEW QUESTION # 12
Exhibit.
Refer to the exhibit, which shows the output of a diagnose command.
What can you conclude about the debug output in this scenario?
- A. There is a natural correlation between the value in the FortiGuard-requests field and the value in the Weight field.
- B. FortiGate used 64.26.151.37 as the initial server to validate its contract.
- C. The first server provided to FortiGate when it performed a DNS query looking for a list of rating servers, was 121.111.236.179.
- D. Servers with a negative TZ value are less preferred for rating requests.
Answer: A
NEW QUESTION # 13
Which two statements about conserve mode are true? (Choose two.)
- A. FortiGate starts dropping all new sessions when the system memory reaches the configured red threshold.
- B. FortiGate starts taking the configured action for new sessions requiring content inspection when the system memory reaches the configured red threshold.
- C. FortiGate enters conserve mode when the system memory reaches the configured extreme threshold.
- D. FortiGate exits conserve mode when the system memory goes below the configured green threshold.
Answer: B,D
NEW QUESTION # 14
Refer to the exhibit, which shows a session entry.
Which statement about this session is true?
- A. Return traffic to the initiator is sent to 10.1.0.1.
- B. It is an ICMP session from 10.1.10.10 to 10.200.1.1.
- C. Return traffic to the initiator is sent lo 10.200.1.254.
- D. It is an ICMP session from 10.1.10.1 to 10.200.5.1.
Answer: D
NEW QUESTION # 15
Refer to the exhibit, which shows partial outputs from two routing debug commands.
Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?
- A. Set snat-route-change to enable.
- B. Set the priority of the static default route using port2 to 1.
- C. Set preserve-session-route to enable.
- D. Set the priority of the static default route using port1 to 10.
Answer: D
NEW QUESTION # 16
Exhibit.
Refer to the exhibit, which shows a FortiGate configuration.
An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however the web filter is not inspecting any traffic that is passing through the policy.
What must the administrator do to fix the issue?
- A. Enable fortiguard-anycast.
- B. Change protocol to TCP.
- C. Disable webfilter-force-off.
- D. Increase webfilter-timeout.
Answer: C
NEW QUESTION # 17
Exhibit.
Refer to the exhibit, which shows a partial web fillet profile configuration.
Which action does FortiGate lake if a user attempts to access www. dropbox. com, which is categorized as File Sharing and Storage?
- A. FortiGate blocks the connection, based on the FortiGuard category based filter configuration.
- B. FortiGate blocks the connection as an invalid URL.
- C. FortiGate allows the connection, based on the URL Filter configuration.
- D. FortiGate exempts the connection, based on the Web Content Filter configuration.
Answer: A
NEW QUESTION # 18
Refer to theexhibit,which shows the output of getrouter info ospf neighbor.
What can you conclude from the command output?
- A. All neighbors are in area 0.0.0.0.
- B. The local FortiGate is the BDR.
- C. The local FortiGate is not a DROther.
- D. The network type connecting the local Fortigate and OSPF neighbor 0.0.0.10 is point-to-point.
Answer: D
NEW QUESTION # 19
Refer to the exhibit, which shows the omitted output of a session table entry.
Which two statements are true? (Choose two.)
- A. The traffic has been tagged for VLAN 0000.
- B. NP7 is handling offloading of this session.
- C. The session has been offloaded.
- D. The traffic matches Policy ID 1.
Answer: B,C
NEW QUESTION # 20
Which two statements about an auxiliary session ate true? (Choose two.)
- A. With the auxiliary session selling disabled, only auxiliary sessions are offloaded.
- B. With the auxiliary session setting disabled, for each traffic path. FortiGate uses the same auxiliary session.
- C. With the auxiliary session setting enabled. Iwo sessions are created in case of routing change.
- D. With the auxiliary session setting enabled. ECMP traffic is accelerated to the NP6 processor.
Answer: C,D
NEW QUESTION # 21
Exhibit.
Refer to the exhibit, which shows the output of diagnose automation test.
What can you observe from the output? (Choose two.)
- A. The test was unsuccessful.
- B. The automation stitch test failed but the HA failover was successful.
- C. An HA failover occurred.
- D. The automation stitch test is not being logged.
Answer: A,D
NEW QUESTION # 22
Which two statements about Security Fabric communications are true? (Choose two.)
- A. The default port for Neighbor Discovery can be modified.
- B. By default, the downstream FortiGate establishes a connection with the upstream FortiGate using TCP port 8013.
- C. FortiTelemetry and Neighbor Discovery both operate using TCP.
- D. FortiTelemetry must be manually enabled on the FortiGate interface.
Answer: B,D
NEW QUESTION # 23
Which statement aboutprotocol options is true?
- A. Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.
- B. Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.
- C. Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.
- D. Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.
Answer: C
NEW QUESTION # 24
Refer to the exhibit, which shows the output of a policy route table entry.
Which type of policy route does the output show?
- A. A regular policy route
- B. An ISDB route
- C. AnSD-WAN rule
- D. A regular policy route, which is associated with an active static route in the FIB
Answer: B
NEW QUESTION # 25
Exhibit.
Refer to the exhibit, which contains partial output from an IKE real-time debug.
Which two statements about this debug output are correct? (Choose two.)
- A. The initiator provided remote as its IPsec peer ID.
- B. It shows a phase 2 negotiation.
- C. Perfect Forward Secrecy (PFS) is enabled in the configuration.
- D. The local gateway IP address is 10.0.0.1.
Answer: A,B
NEW QUESTION # 26
Exhibit.
Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:
However, the IKE real-time debug does not show any output. Why?
- A. Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.
- B. The log-filter setting is incorrect. The VPN traffic does not match this filter.
- C. The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.
- D. The administrator must also run the command diagnose debug enable.
Answer: D
NEW QUESTION # 27
......
Fortinet FCSS_NST_SE-7.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
Try 100% Updated FCSS_NST_SE-7.4 Exam Questions [2025]: https://passguide.validtorrent.com/FCSS_NST_SE-7.4-valid-exam-torrent.html